| |
Welcome.
|
|
|
Regulated DC Power Supply, Unipolar
|
|
Bipolar Limit Detector Module
|
|
Our Price: $170.00
|
|
|
|
Our Price: $300.00
|
|
|
|
|
|
This regulated power supply assembly is designed to convert the AC power line to a stable, low voltage, unipolar DC source. Models are available to provide either 5, 10, 12, 15 or 24 volts DC to the connected load. Models are available with either positive or negative output voltages. This power supply will operate with both 115 or 230 volts AC, single phase, 50 or 60 Hz. power line inputs. This device is typically used to provide a stable power source for transducers and other electronic devices that do not include internal voltage regulators.
|
This bipolar limit detector module is designed to provide a relay contact transfer whenever the input signal exceeds one of the trip point settings. Separate relay outputs are supplied for the positive and negative setpoints. Once the contacts transfer, they will remain so until the input signal returns below the trigger threshold. Models are available for use with either voltage or current input signals. This module can be used in bidirectional applications to indicate a direction change or with double solenoid valves as a level controller. The differential input mode allows the module to transfer the relays based upon the absolute difference between two input signals of the same polarity.
|
|
|
|
Incremental Shaft Encoder, Heavy Duty, PY Mount
|
|
Universal Amplifier and Signal Conditioning Module
|
|
Our Price: $795.00
|
|
|
|
Our Price: $570.00
|
|
|
|
|
|
This series of heavy duty, gear driven, incremental shaft encoders are general purpose devices that are designed to provide position and velocity information to a process control system when they are connected to a rotating shaft on the user's equipment. The large number of pulses per revolution selections that are available enables these units to provide precise velocity feedback signals from very low speed shafts.
|
This universal amplifier module is designed to provide the user with a collection of the most commonly used signal processing functions, preassembled on a single circuit board. All of the basic functions feature compatible signal levels, thus allowing them to be directly interconnected to produce the configuration required for a specific application.
|
|
|
|
Tension Transducer Amplifier Module
|
|
Command Potentiometer, Heavy Duty
|
|
Our Price: $385.00
|
|
|
|
Our Price: $135.00
|
|
|
|
|
|
This load cell amplifier module is designed to interface and provide signal conditioning for either one or two semiconductor strain or foil type load cell transducers, wired in a full bridge configuration. The amplifier is designed to interface with the controls used to monitor and control web tension in the continuous processing of paper, fabric, film, foil and cable.
|
This series of heavy duty controls are general purpose devices that are designed to be panel mounted and used to provide input signals to the user's process control electronics. They are normally used to allow the equipment operator to input speed, position, pressure, torque or additional command information.
|
|
|
|
|
|
